Harness this mini-cultivator for a wide range of applications with an extensive selection of attachments!
Points to keep in mind when engaging in ridge-building work
- Assume that the attachment will descend by only the depth tilled by the rotary shaft (approximately 5 to 10 centimeters) and adjust accordingly.
- Be sure to make adjustments in such a way that the rotary tine and attachment will not come in contact with one another.
- The leading edge of the attachment (plowshare) should be positioned approximately 1 to 3 centimeters above the plow sole.
- If the attachment has a tail wheel, adjust the distance between the underside of the attachment and the protruding parts of the tail
wheel to between approximately 1 and 2 centimeters.
- Proceed to actually build ridges and fine-tune as needed.
Ridging and ridge-building work / Inner-pile and outer-pile with the same unit
Inner-piling shaper★
Code No.31341 10920
Super Green Ridge Builder★
Code No.31343 10980
Ridging and ridge-building work / Build round ridges
Apollo ridger B with tail wheel*
Code No.31341 11830
Mini-Apollo ridger B with tail wheel
Code No.31341 11900
New yellow ridger with tail wheel
Code No.31343 10438
Shuttle ridger with tail wheel
Code No.31341 10538
Ridging and ridge-building work / Build trapezoidal ridges
Plastic ridger B with tail wheel
Code No.31350 30450
Blue ridger with tail wheel
Code No.31350 40150
Earthing up for soybeans / Earth-up to avoid damaging soybean roots
Grooving and soil-lifting /
For developing planting floors inside
greenhouses and earthing/earthing-up
Weeding /
For weeding in spacious locations
To install an attachment denoted with a ★, a separate bolt kit (part no. 1382 8907 000) is required.